The unused leather shows that this is an Aniline Wax Pull-Up leather and Wax Effect-8.6 is recommended to be used as a secondary rejuvenator to achieve the original result, besides the dyes, adhesion and topcoat.
Leather Bond-3D is recommended to be used for the repair; however any repairs on aniline will result in a darker healing mark that is unavoidable even from the tannery.
The recommended structure of restoration process is as follows:
1] Restoration Cleaning:
Use Prep-4.4 > Cleaner-3.8 > Rinse-3.0
2] Hydrating:
Use Hydrator-3.3 for an overnight soak with control evaporation under wrapped.
3] Dry soiling Removal:
Use leather Eraser-4.
4] Stain Dyeing:
Airbrush to even out the difference in color intensity – inspect in between drying until satisfaction.
5] Leather Primary Rejuvenation:
Use Hydrator-3.3 > Fatliquor-5.0.
6] Inspection:
Check all Fatliquor-5.0 strays with Hydrator-3.3 and drive the strays in until hydrator is clear (milky shows the presence of fatliquor on the surface)
7] Pull-up Fashion Secondary Rejuvenation:
Use Wax Effect-8.6 (after a minimum of 4 hours white wax crystal will form on the surface brush them away).
8] Repairs:
Use Leather Bond-3D
9] Adhesion Coating:
Use Adhesor-73
10] Inspection for dyeing appearance:
11] Dye Coating:
This is the optional coating of dyestuff with the additional 10%, 20% to 30% of Adhesor-73 to even out the evenness of dyeing.
12] Top Coating:
Use Aniline Topcoat-79G (gloss).
Shoot your question!
Roger Koh
[email protected]
