Leather Care for 1998 BMW M3 Drivers Seat
Hello,
My drivers seat is showing signs of wear so I'm looking for advise on how to proceed.
The uphostery option is black Nappa leather (N5SW).
The seat, backrest and headrest are leather and the seat back is plastic.
There is dye color lost on the left leg bolster and side bolster. For this reason,
I plan to strip the finish, recondition the leather, re-dye the entire seat and apply
a matte topcoat followed by a protector.
My plan is to remove the seat from the car to perform the work. I'll be doing the
work after-hours at the shop where I work where I will have access to shop air,
a bench, lots of light and (hopefully) more controlled conditions than I would have at home.
I've been reading over the info on the site and beginning to get a grasp of the overall steps
but would like to get your input. Here are some photos of the seats.
-bruce
