Aniline Wax Pull-up Leather Questions!

Quick question, using the Prep to suspend stains...what is the best method to extract?
Have you tried using Clean-3.8 or Rinse-3.0 to wet vac to pull/ remove the particulates in suspension?
Blotting doesn't seem too work.
Any advice?
Also, these areas are the seating areas where most all wax has worn away.

What areT5 towels?
The ones provided in the kit?
Not sure if I have enough Hydrator-3.3 to rinse the mess I made. Hmmm.
Terry towels are very fuzzy and the leather absorbs all liquids quickly.
I never get pooling that can be blotted...I think that’s what you call reverse transfer...correct?
Can I spray distilled water and soak up the stain?
Then spray with "Rinse-3.0" to correct the pH?
Your thoughts?

Here are the photos 44 and 32.
These were small stains; the blotches are the Prep cleaner.
I’ve had them cover with towels for two full days.
Lastly, moving through the steps on ottoman.
I have two applications of the EffectWax-8.6.
However, its still like suede.
You suggestions are very welcome.

#1
Attachment 5901



#2
Attachment 5902



#3
Attachment 5903

>>> Here are the photos 44 and 32. These were small stains;

Some of these small stains or marks are original healing marks sustained from the animal while they were alive and because of the fading it becomes more prominent. When restoring back to its original appearance, these marks becomes less prominent and recognize as mark of genuine leather.


>>> the blotches are the Prep cleaner.

Need to be clean with Clean-3.8 > Rinse-3.0 saturated and terry towel extract.


>>> I’ve had them cover with towels for two full days.

Objective of towel covering is to create a ‘reverse transfer’.
Below surface or structure colloidal movement need to be facilitates (enough moisture content) with Hydrator-3.3 to move them to the surface and trapped through the towel T5 as the moisture contents wick through.


>>> Lastly, moving through the steps on ottoman. I have two applications of the EffectWax-8.6. However, its still like suede.

Surface repairs is done with this sequence of process (optional matching Aniline-21 to "stain"), Hydrator-3.3 (to distribute the dye stain) and to relax the texture roughness, Fatliquor-5.0 to increase or return leather suppleness, EffectWax-8.6 to replenished or restore original pull-up effect, (optional matching Aniline-76 to "coat" all over for even appearance) and the surface roughness is further improved with AnilineTop-76G with sanding with 1200-2000grit sandpaper in between dry to return the finish to original tactile-feel.