Results 1 to 1 of 1

Thread: Leather Conditioner (5)

  1. #1
    Join Date
    Feb 2007
    Location
    Greater Vancouver, Canada.
    Posts
    4,788

    Default Leather Conditioner (5)


    Leather Rejuvenator (5):
    Leather Hydrator,
    Leather Fatliquor,
    Leather Scented Fatliquor,
    Leather Oil Effect,
    Leather Wax Effect,


    Leather Doctor® Hydrator-3.3
    It’s for Pigmented, Aniline, Vachetta, Nubuck, Suede, Hair-on-Hide and Woolskin leather types.
    This is a pH 3.3 aqueous leather-safe hydrator with active surfactantcy for lowering the interfacial tension between the protein leather fibers and its constituents.
    It’s for hydrating dried, stiffed or shrunk leathers to separates the crushed, stick together fibrils and relaxes them in the inter-fibrillary leather structure for effective distribution of the Fatliquor-5.0.
    It’s for charging the leather protein fibers below its iso-electric point positive to hydrogen-bond with the ionic negative charged Fatliquor-5.0.
    It’s for facilitating colloidal water movement within the leather structure during the wicking process to move soiling particulates to the surface.
    It’s for reactivating the dormant dyestuff to resurface thus reducing the contrast between the color coat and the leather crust.
    It’s for reducing the interfacial tension to eliminate blotchiness when dry especially absorbent leathers.
    It’s for facilitating better finish penetration during refinishing thus providing good surface properties, especially the uniformity of surface dyeing during aniline refinishing.
    This product is also available in concentrate to be cut with distilled water at a ratio of 1: 25.
    Thus a 60ml bottle makes 1.64 quarts of Ready-To-Use product to save on shipping.
    Ready-To-Use packing sizes are available in 250ml and in Quart.
    Concentrate packing sizes are available in 60ml (1.64 quarts), 250ml (6.87 quarts) and in Quart (26 quarts).
    Email info@leatherdoctor.com for prices.
    Structural Hydrating Instruction:
    1] Spray soaks evenly into cleaned leather.
    2] Accelerate saturation - work on the reverse side, micro cracks, needle holes or perforation.
    3] Option for even saturation is to cover with absorbent tissue paper and wet thoroughly then seal it up.
    4] Allow a minimum of 4 to 24 hours of dwelling until the leather is fully hydrated, relaxed, evenly wet out or stain dispersed.
    5] Unwrap, extract and saturate with Fatliquor-5.0 to rejuvenate for softness and strength while the leather is moist.

    Leather Doctor® Fatliquor-5.0
    It’s for Pigmented, Aniline, Vachetta, Nubuck, Suede, Hair-on-Hide and Woolskin leather types.
    This is a pH 5.0 anionic charged micro emulsion fatliquor to rejuvenate leather with softness, suppleness and strength.
    It’s for replenishing original fatliquor that diminishes thru sun-bleaching, ageing, heat and alkaline exposure or cleaning.
    It penetrates and lubricates the leather fibers so that after drying they will be capable of sliding over one another smoothly.
    It softens the leather with stretchability, compressibility and flexibility, while enhancing its rip tensile strength greatly.
    It relaxes coarse breaks, creases and wrinkles to provide drapes, suppleness and prevents cracking.
    It helps to keep leather at its optimum physical performance and prevent premature ageing.
    This product is also available in concentrate to be cut with distilled water at a ratio of 1: 5.
    Thus a 250ml bottle makes 1.58 quarts of Ready-To-Use product to save on shipping.
    Ready-To-Use packing sizes are available in 250ml and in Quart.
    Concentrate packing sizes are available in 250ml (1.58 quarts) and in Quart (6 quarts).
    Email info@leatherdoctor.com for prices.
    Instruction:
    1] Shake well, foam brush or spray and ensure even absorption into the leather.
    2] Accelerate penetration - work through the reverse side, micro cracks, needle holes or perforations.
    3] Drive-in dried surface strays from milky to clear - use Hydrator-3.3.
    4] Eliminate coarse breaks and creases - stretch it crosswise while damp.
    5] Achieve extra softness - natural slow drying is preferred.
    6] For desired softness - flex, stake or stretch it when dry.

    Leather Doctor® Fatliquor LS-5.5
    It’s for Micro-Pigmented, Aniline, Vachetta, Nubuck, Suede, Hair-on-Hide and Woolskin leather types.
    This is the leather scented version of the original Fatliquor-5.0 with emphasis to infuse the leather structure with the characteristic classical leather scent.
    This is a pH 5.5 anionic charged micro emulsion fatliquor to rejuvenate leather with softness, suppleness and strength besides the classical leather scent.
    It’s for replenishing original fatliquor that diminishes thru sun-bleaching, ageing, heat and alkaline exposure or cleaning.
    It penetrates and lubricates the leather fibers so that after drying they will be capable of sliding over one another smoothly.
    It softens the leather with stretchability, compressibility and flexibility, while enhancing its rip tensile strength greatly.
    It relaxes coarse breaks, creases and wrinkles to provide drapes, suppleness and prevents cracking.
    It helps to keep leather at its optimum physical performance and prevent premature ageing.
    This product is also available in concentrate to be cut with distilled water at a ratio of 1: 7.
    Concentrate packing sizes are available in 250ml and in Quart.
    Email info@leatherdoctor.com for prices.
    Instruction:
    1] Shake well, foam brush or spray and ensure even absorption into the leather.
    2] Accelerate penetration - work through the reverse side, micro cracks, needle holes or perforations.
    3] Drive-in dried surface strays from milky to clear - use Hydrator-3.3.
    4] Eliminate coarse breaks and creases - stretch it crosswise while damp.
    5] Achieve extra softness - natural slow drying is preferred.
    6] For desired softness - flex, stake or stretch it when dry.

    Leather Doctor® Oil Effect-2.8
    It’s for Aniline and Nubuck oil pull-up leather types.
    This is a pH 2.8 emulsion blend, oil effect leather rejuvenator.
    It’s to rejuvenate diminishing oil pull-up effect lost through usage, ageing or cleaning.
    This product is also available in concentrate to be cut with distilled water at a ratio of 1: 10.
    Thus a 120ml bottle makes 1.39 quarts of Ready-To-Use product to save on shipping.
    Ready-To-Use packing sizes are available in 250ml and in Quart.
    Concentrate packing sizes are available in 120ml (makes 1.39 quarts), 250ml (makes 2.9 quarts) and in quart (makes 11 quarts).
    Email info@leatherdoctor.com for prices.
    Instruction:
    1] Warm up and shake well.
    2] Spread and saturate with foam brush into the leather structure evenly.
    3] Allow 24 hours minimum natural drying time.
    4] Create sharp pull-up effect by kneading, flexing or creasing it.
    5] Impart a buttery-feel non-stick rub-resistant buttery-feel protection with a classic leather scent - use Protection-B+.

    Leather Doctor® Wax Effect-8.6
    It’s for Aniline and Nubuck wax pull-up leather types.
    This is a pH 8.6 aqueous emulsion wax effect leather rejuvenator.
    It’s to rejuvenate wax pull-up effect diminished through usage, ageing or cleaning.
    This product is also available in concentrate to be cut with distilled water at a ratio of 1: 10.
    Thus a 120ml bottle makes 1.39 quarts of Ready-To-Use product to save on shipping.
    Ready-To-Use packing sizes are available in 250ml and in Quart.
    Concentrate packing sizes are available in 120ml (1.39 quarts), 250ml (2.77 quarts) and in Quart (10.5 quarts).
    Email info@leatherdoctor.com for prices.
    Instruction:
    1] Warm up, shake well, spread and saturate with foam brush into the leather structure evenly.
    2] Allow minimum 4 hours natural drying time or until cloudy residual wax shows on the surface.
    3] Activate cloudy residual wax with a heat gun or hair dryer to bring out the natural waxy sheen.
    4] Create pull-up effect by kneading, flexing or creasing it.
    5] Impart a draggy-feel non-stick rub-resistant protection with a classic leather scent - use Protection-D+.
    Last edited by Roger Koh; 01-24-2012 at 02:39 PM.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •