I put two jackets toghther, and the white one is colored by the red one
How can I remove it?
Thank you
#1
#2
#3
I put two jackets toghther, and the white one is colored by the red one
How can I remove it?
Thank you
#1
#2
#3
As this is a buttery soft napa leather finish, the pigment is more absorbent unlike micro-pigment for fashion pants or standard non-absorbent pigment for sportswear.
So a white fashion napa leather jacket finish strength is typically weaker than a white fashion micro-pigment finish pants.
And a white fashion micro-pigment finish pants is typically weaker that a sports pigmented finish.
It is the different finish strength that can withstand wet-rubbing that might affect the color removal.
In worst case the finish need be touch-up – napaColor84 > napaTop78S.
Here is the recommended Dye-Transfer Stain Remover for Napa Finish.
Product Used:
d’Ink7.7 > clean3.8 > rinse3.0.
Instruction:
1] Testing finish strength with a drop of d’Ink7.7 at a hidden corner and let it dwell for half hour and remove by rolling a cotton swab to lift off residue follows with clean3.8 to remove sticky residue and rinse off squeaky clean with rinse3.0.
2] Inspect when dry to see if finish is still intact with satisfaction.
3] If finish is removed abandon the stain removing attempt unless you are prepared with color and topcoat touch-up.
4] Even if color remains unaffected by the stain removal process, it is still advisable to re-topcoat to protect the color coat again.
Hope this helps!
Email me if you wish to have products information.
Roger Koh
[email protected]
See the below thread:
http://www.leathercleaningrestoratio...hread.php?t=67
Bleaching was done to this white Danier® white leather pants.
It is only recommended for non-absorbent leather, the high pH 10.3 when contact the leather crust through the pigmented finishing will “reverse-tanned the leather”.
Roger Koh
Leather Doctor®
There are currently 1 users browsing this thread. (0 members and 1 guests)