Hi Roger,
I've been working on another leather seat (black) along side the beige one, for another vehicle.
Leather was somewhat hard (for it's age)
I followed post #17 and then went to the leather rejuvenation process of applying with a horsehair brush, the hydrator3.3 to saturate the full seat allowed to dwell. Re-application was required as the leather soaked in the hydrtor3.3.
Once the leather was damp after this soaking, fatliquor5.0 was applied and re-applied until the leather showed it was not absorbing anymore.
The leather feel was definitely much softer vs. prior to the start.
I then cleaned off this slight excess film of fatliquor5.0 using the rinse>cleanse>rinse process.
For the leather cracks shown on the seat bottom, I applied the 1:2 ratio mix impregnator26/distilled water, to the cracks shown and wiped off any excess and allowed it to dry.
MY question is, do the fine line cracks in the perforated seat bottom require the application of the bond 3D? Or is this product used for more apparent leather tears and repairs?
