Results 1 to 2 of 2

Thread: Aniline Wax Pull Up-Full Restoration

  1. #1
    Join Date
    Aug 2008
    Posts
    606

    Default Aniline Wax Pull Up-Full Restoration

    Name:  0705161455.jpg
Views: 112
Size:  7.27 MBName:  0705161456b.jpg
Views: 114
Size:  7.67 MBName:  0712160744.jpg
Views: 113
Size:  5.73 MBName:  0712160744c (2).jpg
Views: 112
Size:  6.01 MB

    Cleaned, prepped, cleaned, hydrate and fat liquor. Need to repair, sand and re dye. Then will need to re apply wax. Tips or suggestions?

  2. #2
    Join Date
    Feb 2007
    Location
    Greater Vancouver, Canada.
    Posts
    4,776

    Default

    The sequence should be as follows:

    1 – Prep-4.4 > Clean-3.8 > Prep-4.4 (this is the Restorative Cleaning system)

    2 – Degreaser-2.2 > Acidifier-2.0 (this is the Degreasing system of penetrated body oil, grease and sweat as shown as darker appearance)

    3 – CleanProtein-9.9 > Acidifier-2.0 (this is the Protein stain system for spots that has an outer ring, and as protein stains tends to coagulate removal will need a bamboo skewers or toothpick to work out the crusty stains.)

    4 – Hydrator-3.3 with reverse transfer technique using Towel-5 helps to wick up soiling particulates especially the penetrated body oil, grease and sweat.

    5 – Inspection for stain removal satisfaction otherwise repeat until stain is off the leather surface and work out the stain with Eraser-4 for an even appearance.


    >>> Going to repair tears

    Like to see where the tears are as repairing with Bond-3D will produce an undesired darkening effect, unless the new dye can camouflage it.


    >>> re-dye.

    There are two methods of re-dyeing either with “staining” dyestuff with Aniline-21 or with “coating” dyestuff or both in this sequence.

    Surfactant-3.6 > Aniline-21 > Hydrator-3.3 > Fatliquor-5.0 > EffectWax-8.6 > Aniline-76 > AnilineTop-76G > Protector-D or D+

    A -Surfactant-3.6 purpose is to break surface tension preparing the surface for an even absorbency without blotchiness.

    B - Aniline-21 is the staining dyestuff original used in the tannery and preferably by very light airbrushing for an even appearance.

    C - Hydrartor-3.3 is for helping to redistribute the dyestuff for an even appearance.

    D - Fatliquor-5.0 is for imparting suppleness to the leather.

    E - EffectWax-8.6 is for rejuvenating the characteristic Pull-up effect (Crystal wax deposit is activate with a heat blower to shine).

    F – Aniline-76 as the “coating” dyestuff.

    G – AnilineTop-76G is an extra gloss over the activated wax (if without Anilne-76 or over Aniline-76)

    H – Protector-D or D+ as the finished protector.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •