The pictures i posted above are what the cushions currently look like.
The pictures i posted above are what the cushions currently look like.
When the leather is completely dry, the 'dry process' would be:
1st. Use the nubuck Brush-2 and brush to remove surface residue and extend to the entire cushion.
2nd. Repeat with Eraser-4.
Please show the result.
The cushions are looking better - there are still some dark spots but not too bad. What is the next step?
May need some touch-up re-clean, please show what products you have remain that can be make good used of.
Beside appearance, is there any smell like, sour, ammonic, putrid?
Does the stain area feels as soft as the surrounding areas?
I will take a picture of the products we have left when i get home. There is no ammonic smell but there is a little bit of a sour leather smell but it does not smell like cat urine. The leather does not feel exactly like the surrounding areas but it is much better. We have to do the protector step yet - which i assume is the last step.
Here is what i have of the following chemicals:
Hydrator 3.3 - a small portion at the bottom (not much at all)
D'Urine 2.1 - little less than 3/4 of a bottle
Fat Liquor - 3/4 of a bottle
Acidifier - 3/4 of a bottle
Rinse 3.0 - 1/2 of a bottle
d'Protein 10 - 3/4 of a bottle
Protector S - have not used any of that yet
>>> There is no ammonic smell
The d’Urine-2.1 has done its job!
>>> but there is a little bit of a sour leather smell but it does not smell like cat urine.
The d’Urine-2.1 is still present and will eventually dissipate, this products neutralizes the ammonia and alkaline phosphorus salt found in urine that characterize the smell.
>>> The leather does not feel exactly like the surrounding areas but it is much better.
Not sufficient fatliquor is the reason – may repeat the Hydrator-3.3 > Fatliquor.LS-5.5 system
Do you like the "leather-scent"? (your comment please)
>>> We have to do the protector step yet - which i assume is the last step.
Do not do this step yet if there is a desire to repeat the decontamination and the leather rejuvenating process.
>>> Here is what i have of the following chemicals:
>>> Hydrator-3.3 - a small portion at the bottom (not much at all)
Finish the Hydrator-3.3 to those areas as REPEAT STEP-3
>>> d'Urine-2.1 - little less than 3/4 of a bottle
Job done!
>>> Fatliquor.LS-5.5 - 3/4 of a bottle
This is the reason why “the leather does not feel exactly like the surrounding areas”
Repeat and soak up the leather will soften up the leather tremendously to those areas as REPEAT STEP-4
>>> Acidifier-2.0 - 3/4 of a bottle
Use this remainder to wet the stain out, cover with Towel-T5 and let the stain wick through the towel to be peeled off – as REPEAT STEP-1
>>> Rinse 3.0 - 1/2 of a bottle
Use this remainder to wet the stain out, cover with Towel-T5 and let the stain wick through the towel to be peeled off – as REPEAT STEP-2
>>> d'Protein 10 - 3/4 of a bottle
Job done!
>>> Protector S - have not used any of that yet
Wait until appearance and tactile-feel is satisfactory to the end of the entire process.
Please show pictures of the recommended REPEAT that you are doing it right!
Last edited by Roger Koh; 09-30-2015 at 09:21 AM.
There are currently 1 users browsing this thread. (0 members and 1 guests)