PDA

View Full Version : Bicast - Meltzer- Very worn welts,



chet
09-14-2015, 08:46 AM
Roger, this lounge cushion is in good shape except for the welting around it. We cleaned, hydrated and fat liquored. Then applied Impregnator several times after it dried. It is very rough and I want to repair it.
How should we proceed?

5513
9-14A

5514
9-14B

Roger Koh
09-14-2015, 09:18 AM
>>> It is very rough and I want to repair it. How should we proceed?

1- Remove remnants of the finishes clean by Razor-60 or equivalent.
2- Sanding with a Dremel mini grinder for easier control to smooth out the roughness.
3- Adhesor-73 used.
4- Primary ‘opaque’ matching Micro-54
5- Secondary ‘transparent’ matching Aniline-76
6- AnilineTop-76G (gloss or satin) to match.
7- Protector-B/B+ to reduce wear now and during routine or periodic care

chet
09-14-2015, 09:45 AM
Roger, under closer inspection, I the welt was made out of vinyl, it looks like fabric where the top coat is worn off. Can I fix this with your products?

Roger Koh
09-14-2015, 09:53 AM
Use Bond-3D to disguise the fabric texture prior to Adhesor-73.